Bridge Macadd - THOMSON SpeedTouch 608 Cli Reference Manual

bridge macadd

Add a static MAC address to the filtering database.
This command allows to manually add static addresses, which should normally be dynamically discovered by the bridge
itself.
SYNTAX:
bridge macadd
where:
intf
hwaddr
EXAMPLE:
=>bridge maclist
00:0d:9d:47:dd:aa -- dynamic, ethport1, 300 seconds
00:90:d0:72:88:64 -- permanent
01:00:5e:00:00:67 -- static
01:00:5e:7f:ff:fa -- static
01:80:c2:00:00:00 -- permanent
01:80:c2:00:00:01 -- permanent
01:80:c2:00:00:02 -- permanent
01:80:c2:00:00:03 -- permanent
...
01:80:c2:00:00:0e -- permanent
01:80:c2:00:00:0f -- permanent
01:80:c2:00:00:10 -- permanent
ff:ff:ff:ff:ff:ff -- permanent
=>bridge macadd intf=ethport2 hwaddr=00:80:9f:01:23:45
=>bridge maclist
00:0d:9d:47:dd:aa -- dynamic, ethport1, 300 seconds
00:80:9f:01:23:45 -- static
00:90:d0:72:88:64 -- permanent
01:00:5e:00:00:67 -- static
01:00:5e:7f:ff:fa -- static
01:80:c2:00:00:00 -- permanent
01:80:c2:00:00:01 -- permanent
01:80:c2:00:00:02 -- permanent
01:80:c2:00:00:03 -- permanent
01:80:c2:00:00:0e -- permanent
01:80:c2:00:00:0f -- permanent
01:80:c2:00:00:10 -- permanent
ff:ff:ff:ff:ff:ff -- permanent
=>
RELATED COMMANDS:
bridge macdelete
bridge maclist
E-DOC-CTC-20040216-0002 v1.0
intf = <intfname>
hwaddr = <hardware-address>
The name of the bridge interface for which the MAC address must be
added.
The Ethernet MAC address of the new entry.
Delete a MAC address entry.
Show current filtering database.
Bridge Commands
REQUIRED
REQUIRED
61