Table of Contents
Advertisement
Access via a Telnet Session or Serial Console
Proceed as follows to open a Telnet session:
Open a Command Prompt window, e.g. by clicking Start > All Programs > Accessories > Command Prompt.
1
At the prompt, type telnet followed by the IP address of the SpeedTouch™ (default is 10.0.0.138).
2
As soon a session to the CLI is opened, the SpeedTouch™ banner pops up, followed by the CLI prompt.
If the SpeedTouch™ is protected by a username and a system password, authentication will be required before access is
granted.
The following figure shows an example of the SpeedTouch™608 banner after opening a session and authentication.
Username : johndoe
Password : *******
------------------------------------------------------------------------
*
*
*
*
*
_____/__
*
_/
*
//
*
_______//_______/
*
/
/ \
*
__/
/
\
*
/ /
/
\_______\/
* /_/______/___________________/ /________/ /___/
* \ \
\
___________
*
\_\
\
/
*
\
\/
*
\_____/
*
/__________/
*
\
_____
*
\ /
*
/____/
*
\
\
*
\____\/
*
------------------------------------------------------------------------
=>
E-DOC-CTC-20040216-0002 v1.0
______
SpeedTouch 608
___/_____/\
/
/\\
Version 4.2.7.8
/
\\
/\_____/___ \
/
\
/\ \
\
/ _\/______
\
/
/ /
\
/
/ /
/ /
\ \
/\
\ \
/
\
\ \
/
\
\ \________\/
\
\
/
\
/_____\/
/\
\
/___\/
\
\
/
/___\/
Copyright (c) 1999-2004,
THOMSON
/\
/ _\__
/ /
/\
\
\ \
\
/
\ \___\/
\
/
CLI Navigation
21
- Quick Links:
- Accessing the Command Line Interface
Hide quick links:
Advertisement
Table of Contents
