Dhcp Server Config - THOMSON SpeedTouch 608 Cli Reference Manual

DHCP Commands

dhcp server config

Show/set SpeedTouch™ DHCP server configuration settings.
SYNTAX:
dhcp server config
where:
autodhcp
scantime
state
trace
EXAMPLE:
=>dhcp server config
autodhcp: on
scantime: 20s
state: disabled
tracing: off
=>dhcp server config scantime=30 tracing=on
=>dhcp server config
autodhcp: on
scantime:30s
state: disabled
tracing: on
=>
RELATED COMMANDS:
dhcp server stats
108
[autodhcp = <{off|on}>]
[scantime = <number>]
[state = <{disabled|enabled}>]
[trace = <{off|on}>]
Allow the SpeedTouch™ to present itself as DHCP client
(AutoDHCP mode) at boot time and probe for another DHCP
server on the network for some time before starting its own DHCP
server (on) or immediately start the DHCP server (off).
A number between 0 and 1814400 (seconds).
Represents the time for which the SpeedTouch™ scans for another
DHCP server to be active in the network.
The default is 20.
State of the DHCP server (enabled/disabled).
Disable (off) or enable (on) verbose console logging and generation
of debug traces.
The default is off.
Show current DHCP server state and statistics.
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040216-0002 v1.0