THOMSON SpeedTouch 608 Cli Reference Manual page 319

prot
srcport
srcportend
dstport
dstportend
clink
log
label
E-DOC-CTC-20040216-0002 v1.0
The protocol (name or number) expected in the IP packet.
Select one of the following protocol names:
•
icmp
•
igmp
•
ipinip
•
tcp
•
udp
•
ah
•
esp
•
ipcomp
or, alternatively, specify the protocol number.
The TCP/UDP port (or beginning of range) the packet is coming
from.
Select one of the supported TCP/UDP port names (See
" Supported TCP/UDP Port Names" on page 480
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
The source TCP/UDP port range end (inclusive) (only applicable for
ranges).
Select one of the supported TCP/UDP port names (See
" Supported TCP/UDP Port Names" on page 480
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
The TCP/UDP port (or beginning of range) the packet is going to.
Select one of the supported TCP/UDP port names (See
" Supported TCP/UDP Port Names" on page 480
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
The destination TCP/UDP port range end (inclusive) (only
applicable for ranges).
Select one of the supported TCP/UDP port names (See
" Supported TCP/UDP Port Names" on page 480
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
The name of the chain to be parsed when this rule applies.
Logging is done when this rule applies.
Choose between no or yes.
Choose between:
•
None
•
link (when clink is used)
•
label name.
Label Commands
OPTIONAL
OPTIONAL
for a listing of
OPTIONAL
for a listing of
OPTIONAL
for a listing of
OPTIONAL
for a listing of
OPTIONAL
OPTIONAL
REQUIRED
317