Dhcp Client Ifconfig - THOMSON SpeedTouch 608 Cli Reference Manual

DHCP Commands

dhcp client ifconfig

Show/set the configuration of DHCP lease created for a specific interface.
Use the command dhcp client ifrelease before configuring the dhcp client.
Note
SYNTAX:
dhcp client ifconfig
where:
intf
clientid
hostname
addr
leasetime
addrtrans
dns
gateway
metric
dnsmetric
90
intf = <interface name>
[clientid = <{client-id|none}>]
[hostname = <hostname|"">]
[addr = <ip-address>]
[leasetime = <number>]
[addrtrans = <{none|pat}>]
[dns = <{off|on}>]
[gateway = <{off|on}>]
[metric = <number{0-100}>]
[dnsmetric = <number{0-100}>]
The name of the dynamic interface to be configured.
The client identity to be associated with the lease.
Use none in case no clientid should be associated with this lease.
The host name of the client to be associated with the lease.
Use "" in case no hostname should not be associated with this lease.
The preferred dynamic IP address.
A number between 0 and 1814400 (seconds).
Represents the preferred time the client wants to use an address.
The default is 7200 (2 hours).
Specifying -1 makes the lease permanent.
Note
Automatically enable address translation for this dynamic interface
(pat) or not (none).
Request (and accept) DNS server IP addresses (on) or not (off).
Request (and accept) gateway IP addresses (on) or not (off).
A number between 0 and 100.
Represents the gateway route metric.
The default is 1.
A number between 0 and 100.
Represents the DNS route metric.
The default is 1.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040216-0002 v1.0