Pppoe Iflist - THOMSON SpeedTouch 608 Cli Reference Manual

PPPoE Commands

pppoe iflist

Show current configuration of all or a specified PPPoE interface(s).
SYNTAX:
pppoe iflist
where:
intf
EXAMPLE INPUT/OUTPUT :
=>pppoe iflist
PPPoE1: dest : PPPoE1
Retry: 10 QoS
mode = IP Routing
flags = echo magic
trans addr = pat
route = 0.0.0.0/0 - 0.0.0.0/0 (metric 0)
user name = guest
admin state = down
LCP: state = initial
IPCP: state = initial
PPPoE2: dest : PVC2
Retry: 10 QoS
mode = IP Routing
flags = echo magic
mru = 1500
user name = password =
admin state = down
LCP: state = initial
IPCP: state = initial
=>
RELATED COMMANDS:
pppoe ifadd
pppoe ifattach
pppoe ifconfig
pppoe ifdelete
pppoe ifdetach
382
[intf = <intfname>]
The name of the PPPoE interface.
If this parameter is not specified, all PPPoE interfaces are shown.
default encaps
accomp restart mru
mru = 1500
password = ********
oper state = down
retransm = 10
retransm = 0
default encaps
accomp restart mru
oper state = down
retransm = 10
retransm = 0
Create a new PPPoE interface.
Attach a PPPoE interface.
Configure a PPPoE interface.
Delete a PPPoE interface.
Detach a PPPoE interface.
VC-MUX
addr route savepwd
link state = not-connected
term. reason =
term. reason =
VC-MUX
addr savepwd PPPoEOA
link state = not-connected
term. reason =
term. reason =
OPTIONAL
PPPoEOA
E-DOC-CTC-20040216-0002 v1.0