Nat Multinatadd - THOMSON SpeedTouch 608 Cli Reference Manual

nat multinatadd

Add a MultiNAT configuration.
SYNTAX:
nat multinatadd
where:
intf
inside_addr
outside_addr
addroute
EXAMPLE:
=>ip rtlist
Destination Label
169.254.141.11/32
255.255.255.255/32
10.0.0.138/32
127.0.0.1/32
10.0.0.0/24
169.254.0.0/16
224.0.0.0/4
=>nat multinatadd intf=PPPoE_1 inside_addr=10.0.0.1 outside_addr=10.10.0.138
=>nat multinatlist
Indx Intf
64 PPPoE_1
=>ip rtlist
Destination Label
0.0.0.0/0
169.254.141.11/32
255.255.255.255/32
10.0.0.138/32
127.0.0.1/32
10.0.0.0/24
169.254.0.0/16
224.0.0.0/4
=>
RELATED COMMANDS:
nat multinatdelete
nat multinatlist
E-DOC-CTC-20040216-0002 v1.0
intf = <string>
inside_addr = <ip-range>
outside_addr = <ip-range>
[addroute = <{no|yes}>]
The IP interface name where MultiNAT has to be applied.
The IP address of the host behind the address translation device that will
receive the incoming traffic. Typically, a private IP address.
The apparent host IP address this application will running on.
Use 0 to create a template.
Add multinat label routes automatically or not. The default is yes.
169.254.141.11
10.0.0.138
10.0.0.138
127.0.0.1
10.0.0.138
169.254.141.11
10.0.0.138*
Inside-address
10.0.0.1
_from_10.0.0.1/32
169.254.141.11
169.254.141.11
Delete a MultiNAT configuration.
List MultiNAT configurations.
Gateway Intf Mtrc Status
eth0
eth0
eth0
loop
eth0
eth0
eth0
Outside-address
10.10.0.138
Gateway Intf Mtrc Status
10.10.0.138 PPPoE_1
eth0
10.0.0.138 eth0
10.0.0.138 eth0
127.0.0.1 loop
10.0.0.138 eth0
eth0
10.0.0.138* eth0
0 [UP]
0 [UP]
0 [UP]
0 [UP]
0 [UP]
0 [UP]
0 [UP]
Static MultiNAT
0 [UP]
0 [UP]
0 [UP]
0 [UP]
0 [UP]
0 [UP]
0 [UP]
0 [UP]
NAT Commands
REQUIRED
REQUIRED
REQUIRED
OPTIONAL
343