THOMSON SpeedTouch 608 Cli Reference Manual page 387

srcmsk
metric
EXAMPLE:
=>pppoe iflist
PPPoE1: dest : PVC3
Retry: 10 QoS
mode = IP Routing
flags = echo magic
trans addr = pat
user name = guest
admin state = down
LCP : state = initial
IPCP: state = initial
=>pppoe rtadd intf=PPPoE1 dst=172.16.0.5 dstmsk=24 src=10.0.0.2 srcmask=24
=>pppoe iflist
PPPoE1: dest : PVC3
Retry: 10 QoS
mode = IP Routing
flags = echo magic
trans addr = pat
route = 10.0.0.2/24 - 172.16.0.5/24 (metric 1)
user name = guest
admin state = down
LCP : state = initial
IPCP: state = initial
=>
RELATED COMMANDS:
pppoe rtdelete
E-DOC-CTC-20040216-0002 v1.0
The source IP mask.
Depending on the source netmask:
•
Everybody is allowed to use this PPPoE connection (dstmsk=0)
•
Only members of the same subnet as the host which opened the
PPPoE connection are allowed to use the PPPoE connection
(dstmsk=1)
•
The actual destination mask will be the netmask applicable for the IP
address of the host which opened the PPPoE connection.
•
Only the host which opened the PPPoE connection is allowed to use
the PPPoE connection (dstmsk=32)
•
Any valid (contiguous) netmask in case of VLSM.
The route metric, i.e. the cost factor of the route.
Practically, the cost is determined by the hop count.
default encaps
accomp restart mru
mru = 1492
password = ********
oper state = down
retransm = 10
retransm = 0
default encaps
accomp restart mru
mru = 1492
password = ********
oper state = down
retransm = 10
retransm = 0
Delete the route specification for an upcoming PPPoE link.
LLC
addr route savepwd
link state = not-connected
term. reason =
term. reason =
LLC
addr route savepwd
link state = not-connected
term. reason =
term. reason =
PPPoE Commands
OPTIONAL
OPTIONAL
PPPoE
PPPoE
385