Routed Pppoe - THOMSON SpeedTouch 605 User Manual

5.4.2 Routed PPPoE

Introduction
Creating a Routed
PPPoE connection entry
Additional configuration
Routing
E-DOC-CTC-20051017-0151 v1.0
The Routed PPPoE configuration page allows you to add new Routed PPPoE, or
Routed PPPoE Relay connection entries or to change settings of existing entries.
To add a Routed PPPoE connection entry:
1
Click New.
2
In the Interface box, type a unique interface name (different from the MER
interface name).
3
In the Destination list, click the appropriate Routed Ethernet destination
indicated by the Routed Ethernet interface name
4
Type user name and password for the account at the ISP [optional].
5
If applicable, type a Service name and/or Access Concentrator [optional]
6
Click Apply.
Once created, per Routed PPPoE connection, additional configuration is possible by
clicking:
Routing
Other
These parameters can only be modified when the link is down. Take the link
down first by clicking Hang-up.
Following fields are available:
Destination:
Controls the networks that can be reached via this particular PPP connection.
Specify the remote host or network in prefix notation. e.g. 172.16.0.0/16.
Label:
Allows you to assign a label to this connection.
Chapter 5
Expert Configuration
139