Cam Chain Tensioner Inspection - Suzuki Intruder VZ1500 Service Manual

1D-73 Engine Mechanical:
• Apply engine coolant to the O-ring.
NOTE
Use a new O-ring to prevent engine coolant
leakage.
• Tighten the water inlet pipe mounting bolts.
Clutch Release Assembly / Push Rod
Install the push rod and clutch release assembly. Refer
to "Clutch Release Assembly / Push Rod Removal and
Installation in Section 5C (Page 5C-2)".
Starter Motor
• Apply grease to the O-ring.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
Replace the O-ring with a new one.
• Tighten the starter motor mounting bolts (1) to the
specified torque.
Tightening torque
Starter motor mounting bolt (a): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
I940H1140254-01
Engine Top Side
Assembly the engine top side. Refer to "Engine Top Side
Assembly (Page 1D-32)".

Cam Chain Tensioner Inspection

Inspect the cam chain tensioner in the following
procedures:
1) Remove the cam chain tensioner. Refer to "Engine
Bottom Side Disassembly (Page 1D-56)" and
"Engine Bottom Side Assembly (Page 1D-64)".
2) Check the contacting surface of the cam chain
tensioner. If it is worn or damage, replace it with a
new one.
3) Install the cam chain tensioner. Refer to "Engine
I940H1140255-01
Bottom Side Disassembly (Page 1D-56)" and
"Engine Bottom Side Assembly (Page 1D-64)".
1
(a)
I940H1140256-02
B940H21406034
I940H1140371-01