Suzuki Intruder VZ1500 Service Manual page 421

3) Install the oil seal with the special tool.
CAUTION
!
The removed oil seal must be replaced with a
new one.
Special tool
(A): 09913–70210 (Bearing installer set)
4) Install the bearing housing (1) and tighten the
bearing stopper (2) to the specified torque with the
special tool.
CAUTION
!
Replace the bearing stopper (2) with a new
one.
Special tool
(C): 09924–41830 (Bearing retainer wrench)
Tightening torque
Secondary driven bevel gear bearing stopper
(a): 105 N·m (10.5 kgf-m, 76.0 lbf-ft)
2
(a)
(C)
(A)
I940H1310040-01
1
I940H1310041-02
Drive Chain / Drive Train / Drive Shaft:
5) Lock the bearing stopper (3) with a center punch.
6) Install the secondary driven bevel gear (4),
secondary driven bevel gear spacer (5) and bearing
housing (3) to the shaft (6).
3
7) Apply grease to the lip of oil seal and O-ring and
install the secondary shaft spacer (7).
CAUTION
!
Replace the O-ring with a new one.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
7
3A-7
3
I940H1310042-01
6
5
4
I940H1310043-01
I940H1310044-01