Suzuki Intruder VZ1500 Service Manual page 177

EVAP System Purge Control Solenoid Valve
NOTE
EVAP system purge control solenoid valve
can be checked without removing it from the
motorcycle. Refer to "DTC "C62" (P0443):
EVAP System Purge Control Solenoid Valve
Circuit Malfunction (For E-33) in Section 1A
(Page 1A-93)".
1) Check that no air flows through both of the air inlet
and outlet ports. If air flows out, replace the EVAP
system purge control solenoid valve with a new one.
2) Connect the 12 V battery to the terminals of the
EVAP system purge control solenoid valve and
check the air flow. If air flows out, the solenoid valve
is in normal condition.
3) Check the resistance between the terminals of the
EVAP system purge control solenoid valve. If the
resistance is not within the standard range, replace
the EVAP system purge control solenoid valve with a
new one.
Special tool
Tester knob indication
Resistance (Ω)
EVAP system purge control solenoid valve
resistance
Approx. 32 Ω at 20 °C (68 °F)
I822H1120026-01
Fuel Shut-Off Valve
Inspect the fuel shut-off valve body for damage. Inspect
the fuel shut-off valve operation in the following
procedures:
1) When air is blown into the fuel shut-off valve with its
side "A" positioned upward, the air can pass through
to the canister side.
I822H1120027-01
Emission Control Devices:
(A): 09900–25008 (Multi-circuit tester set)
(A)
1B-13
I822H1120028-01
"A"
I823H1120037-01