Stp Sensor Removal And Installation - Suzuki Intruder VZ1500 Service Manual

6) Close the secondary throttle valve by finger and
measure the STP sensor output voltage.
Special tool
(A): 09900–28630 (TPS test wire harness)
(B): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Voltage ( )
STP sensor output voltage
ST valve is fully closed: Approx. 0.6 V ((+): Y/W –
(–): B/Br)
(B)
7) Loosen the STP sensor mounting screw adjust the
STP sensor (2) until the output voltage comes within
the specified value and tighten the STP sensor
mounting screw.
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
STP sensor mounting screw: 3.5 N·m (0.35 kgf-
m, 2.5 lbf-ft)
2
8) Disconnect the special tool and reinstall the removed
parts.

STP Sensor Removal and Installation

Removal
1) Turn the ignition switch OFF.
2) Move the each air cleaner box and lift and support
the air cleaner chamber. Refer to "Air Cleaner
Chamber Removal and Installation in Section 1D
(Page 1D-7)".
NOTE
It is unnecessary to remove the sensors and
hoses.
I940H1130020-01
(A)
3) Disconnect the coupler (1) and remove the STP
sensor (2) with the special tool.
NOTE
Prior to disassembly, mark each sensor's
original position with a paint or scribe for
accurate reinstallation.
I940H1130021-02
Special tool
I940H1130022-02
Engine Electrical Devices:
: 09930–11950 (Torx wrench)
2
1
1C-7
B940H21306016
I940H1130023-01
I940H1130024-01