Table of Contents
Advertisement
1E-7 Engine Lubrication System:
• Tighten the oil jet plate bolts securely.
Oil Jet (For Transmission)
Removal
1) Remove the engine assembly. Refer to "Engine
Bottom Side Disassembly in Section 1D (Page 1D-
56)".
2) Separate the crankcases, upper and lower. Refer to
"Engine Bottom Side Disassembly in Section 1D
(Page 1D-56)".
3) Remove the oil gallery plugs (1) and (2).
1
4) Remove the oil jet (3) with a suitable bar.
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Apply engine oil to the O-ring.
Use a new O-ring to prevent oil leakage.
I940H1150024-01
• Apply thread lock to the thread part and tighten the oil
gallery plug (1) to the specified torque.
Use a new gasket to prevent oil leakage.
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
2
Oil gallery plug (M10) (a): 18 N·m (1.8 kgf-m, 13.0
lbf-ft)
I940H1150025-01
3
I940H1150026-02
CAUTION
!
CAUTION
!
: Thread lock cement 99000–32030
1
(a)
I940H1150027-01
I940H1150028-01
Advertisement
Chapters
Table of Contents
