Rear Turn Signal Light Removal and Installation
Removal
1) Remove the rear fender. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
5)".
2) Remove the rear fender from the rear fender brace.
Refer to "Rear Fender Construction in Section 9D
(Page 9D-4)".
3) Disconnect the rear turn signal light coupler (RH:
Black LH: Gray) (1).
1
4) Remove the clamps (2).
5) Remove the rear turn signal (3).
3
Installation
Install the rear turn signal light in the reverse order of
removal.
B940H29206014
1
I940H1920023-01
2
I940H1920024-01
3
I940H1920025-01
Turn Signal Light Bulb Replacement
CAUTION
!
When you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
1) Remove the screw (1).
2) Remove the rear turn signal lens (2).
3) Replace the bulb (3).
4) Reinstall the lens.
Lighting Systems:
9B-9
B940H29206015
1
I940H1920026-01
2
I940H1920027-01
3
I940H1920028-01