Battery Visual Inspection - Suzuki Intruder VZ1500 Service Manual

1J-12 Charging System:
8) Remove the side stand relay. Refer to "Turn Signal /
Side-stand Relay Removal and Installation in
Section 1I (Page 1I-8)".
9) Lift the battery holder (9) by removing the bolts.
10) Remove the shut-off valve (10).
11) Remove the TO sensor (11) and cooling fan relay
(12).
12
11
9
I940H11A0022-01
10
I940H11A0023-01
I940H11A0024-02
Installation
Install the battery holder and battery in the reverse order
of removal. Pay attention to the following points:
• Install the battery.
CAUTION
!
Never use anything except the specified
battery.
• Tighten the battery lead wire mounting bolts securely.

Battery Visual Inspection

Inspect the battery in the following procedures:
1) Remove the seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-5)".
2) Visually inspect the surface of the battery container.
If any signs of cracking or electrolyte leakage from
the sides of the battery have occurred, replace the
battery with a new one.
If the battery terminals are found to be coated with
rust or an acidic white powdery substance, clean the
battery terminals with sandpaper.
3) Install the seat. Refer to "Exterior Parts Removal and
Installation in Section 9D (Page 9D-5)".
I940H11A0025-01
B940H21A06009