Table of Contents
Advertisement
9C-6 Combination Meter / Fuel Meter / Horn:
Fuel Level Indicator Inspection
Inspect the fuel level indicator in the following
procedures:
1) Support the motorcycle with a jack or wooden block.
2) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)".
3) Disconnect the fuel level gauge coupler (1).
4) Connect variable resistor (2) between the B/Lg and
B/W lead wires from the wire harness.
5) Turn the ignition switch ON.
6) Check the display of fuel level indicator (LCD) as
shown in the figure.
If any abnormality is found, replace the combination
meter with a new one. Refer to "Combination Meter
Removal and Installation (Page 9C-2)".
NOTE
Side-stand is "ON" (side-stand up) position
when inspecting it.
B940H29306008
1
I940H1930033-01
2
I940H1930017-01
Resistance
Thermistor
—
ON
More than
OFF
134 Ω
78 – 134 Ω
OFF
38.3 – 78 Ω
OFF
16.6 – 38.3 Ω
OFF
Less than
OFF
16.6 Ω
7) Connect the fuel level gauge coupler and reinstall
the fuel tank.
Refer to "Fuel Tank Removal and Installation in
Section 1G (Page 1G-9)".
Fuel Level Indicator Switch (Thermistor)
Inspection
Inspect the fuel level indicator switch in the following
procedures:
1) Remove the fuel pump. Refer to "Fuel Pump
Assembly / Fuel Level Gauge Removal and
Installation in Section 1G (Page 1G-12)".
2) Remove the thermistor from the fuel pump. Refer to
"Fuel Pump Disassembly and Assembly in Section
1G (Page 1G-13)".
3) Connect 12 V battery and test bulb (12 V, 3.4 W) to
the fuel level indicator switch as shown in the figure.
The bulb should come on after one minutes if the
switch is in good condition.
ON
Test bulb
Fuel level meter
Flicker
E
F
E
F
E
F
E
F
E
F
E
F
I940H1930018-04
B940H29306009
Battery
I822H1930010-03
Advertisement
Chapters
Table of Contents
