Oil Pressure Switch Removal And Installation; Ignition Switch Inspection; Ignition Switch Removal And Installation; Horn Inspection - Suzuki Intruder VZ1500 Service Manual

1) Disconnect the oil pressure switch lead wire (1) from
the oil pressure switch.
2) Turn the ignition switch ON.
3) Check if the oil pressure indicator (LED) and LCD
will light up when grounding the lead wire (1).
If the oil pressure indicator does not light up, replace
the combination meter unit with a new one after
checking the connection of couplers.
1

Oil Pressure Switch Removal and Installation

Refer to "Oil Pressure Switch Removal and Installation in
Section 1E (Page 1E-5)".

Ignition Switch Inspection

Inspect the ignition switch in the following procedures:
1) Remove the left frame side cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-5)".
2) Disconnect the ignition switch coupler (1).
1
1
I940H1930023-01

Ignition Switch Removal and Installation

Refer to "Ignition Switch Removal and Installation in
Section 1H (Page 1H-10)".

Horn Inspection

Horn Button Inspection
I940H1930024-03
B940H29306015
B940H29306016
I940H1930025-01
Combination Meter / Fuel Meter / Horn:
3) Inspect the ignition switch for continuity with a tester.
If any abnormality is found, replace the ignition
switch with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
R
Position
OFF
ON
P
4) After finishing the ignition switch inspection, reinstall
the removed parts.
NOTE
If the horn sound condition is normal, it is not
necessary to inspect the horn button
continuity.
1) Turn the steering to the left.
2) Disconnect the left handlebar switch coupler (1).
O O/Y Gr Br
I822H1930021-06
B940H29306017
B940H29306018
1
I940H1180014-03
9C-9