Table of Contents
Advertisement
2) Measure the battery voltage using the multi-circuit
tester.
If the voltage reading is less than the 12 V (DC),
recharge the battery with a battery charger.
Recharging time
1.8 A for 5 to 10 hours or 9 A for 1 hour
CAUTION
!
Be careful not to permit the charging current
to exceed 9 A at any time.
3) After recharging, wait at least 30 minutes and then
measure the battery voltage using the multi-circuit
tester.
If the battery voltage is less than 12.5 V, recharge
the battery again.
If the battery voltage is still less than 12.5 V after
recharging, replace the battery with a new one.
"A"
"B"
"A": Charging period
4) Install the battery to the motorcycle. Refer to "Battery
/ Battery Holder Removal and Installation (Page 1J-
11)".
I649G11A0045-02
"B": Stop charging
I705H11A0029-02
Battery / Battery Holder Removal and
Installation
Removal
1) Remove the seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-5)".
2) Disconnect the battery (–) lead wire (1).
3) Disconnect the battery (+) lead wire (2).
NOTE
Be sure to disconnect the battery (–) lead
wire (1) first, then disconnect the battery (+)
lead wire (2).
4) Remove the battery (3) from the motorcycle.
3
5) Remove the ECM. Refer to "ECM Removal and
Installation in Section 1C (Page 1C-1)".
6) Remove the starter relay (4) along with the (+) lead
wire (5). Refer to "Starter Relay Removal and
Installation in Section 1I (Page 1I-7)".
5
7) Remove the fuse box (6), fuel pump relay (7) and
headlight relay (8).
6
Charging System:
1J-11
B940H21A06008
1
2
I940H11A0019-01
4
I940H11A0020-01
7
8
I940H11A0021-02
Advertisement
Chapters
Table of Contents
