Crankshaft Thrust Clearance Inspection And Adjustment - Suzuki Intruder VZ1500 Service Manual

• Apply enough engine oil to the special tool and the
bearings and then set the special tool carefully.
• Gradually press in the bearing (1) into the main
journal bore by using the hydraulic press until the
special tool (2) stops the special tool (3).
Special tool
(A): 09913–60250 (Journal bearing remover/
installer)
(A)
(A)
3
2
• Measure the clearance from case surface to bearing
(1).
"a": 1.0 mm (0.04 in)
I940H1140336-01
3
1
2
(A)
1
I940H1140283-03
" a "
1
I940H1140284-01
• After installing the bearings, check the bearing
surface for any scratch or damage.
Crankshaft Thrust Clearance Inspection and
Adjustment
Refer to "Engine Bottom Side Disassembly (Page 1D-
56)".
Refer to "Engine Bottom Side Assembly (Page 1D-64)".
Inspection
1) Install the crankshaft in the right crankcase half after
installing the thrust shim (1) on the crankshaft.
NOTE
The oil grooved face "A" of thrust shim (1) is
faced to crankshaft web side.
Engine Mechanical: 1D-80
I940H1140286-01
B940H21406040
1
"A"
I940H1140287-01