NOTE
Make sure the STP valve open or close
smoothly. If the STP sensor adjustment is
necessary, refer to "STP Sensor Adjustment
in Section 1C (Page 1C-6)".
• Apply thin coat of the engine oil to the O-ring.
CAUTION
!
Replace the O-ring with a new one.
• With the throttle valve fully closed, install the TP
sensor (2) and tighten the TP sensor mounting screw
to the specified torque.
NOTE
• Align the throttle shaft end "C" with the
groove "D" of the TP sensor.
• Apply grease to the throttle shaft end "C",
if necessary.
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
TP sensor mounting screw: 3.5 N·m (0.35 kgf-m,
2.5 lbf-ft)
2
"D"
I940H1140041-01
"C"
I940H1140042-01
NOTE
Make sure the throttle valve open or close
smoothly. If the TP sensor adjustment is
necessary, refer to "TP Sensor Adjustment in
Section 1C (Page 1C-3)".
• Apply thin coat of the engine oil to the new cushion
seal (4) and O-ring (5).
CAUTION
!
Replace the cushion seal and O-ring with the
new ones.
4
Engine Mechanical:
1D-16
I940H1140043-01
5
I940H1140044-01