Table of Contents
Advertisement
• Tighten the cushion lever mounting nut to the
specified torque.
Tightening torque
Cushion lever mounting nut (e): 132 N·m (13.2
kgf-m, 95.5 lbf-ft)
• Install the rear brake pipe as shown in the rear brake
hose routing diagram. Refer to "Rear Brake Hose
Routing Diagram in Section 4A (Page 4A-2)".
Rear Suspension Inspection
Refer to "Rear Suspension Inspection in Section 0B
(Page 0B-18)".
Rear Shock Absorber Removal and Installation
Refer to "Swingarm Assembly Removal and Installation
(Page 2C-3)".
Rear Shock Absorber Inspection
Inspect the rear shock absorber in the following
procedures:
1) Remove the rear shock absorber. Refer to "Rear
Shock Absorber Removal and Installation (Page 2C-
6)".
2) Inspect the rear shock absorber for damage and oil
leakage, and absorber bushing for wear and
damage. If any defect is found, replace the rear
shock absorber with a new one.
CAUTION
!
Do not attempt to disassemble the rear shock
absorber. It is unserviceable.
(e)
Rear Suspension Adjustment
I940H1230015-02
After installing the rear suspension, adjust the spring
pre-load and damping force as follows:
Spring Pre-load Adjustment
B940H22306004
B940H22306005
STD position "a"
192 mm (7.56 in)
B940H22306006
3) Install the rear shock absorber. Refer to "Swingarm
Assembly Removal and Installation (Page 2C-3)".
1) Remove the left frame side cover and left frame
lower cover. Refer to "Exterior Parts Removal and
Installation in Section 9D (Page 9D-5)".
2) Turn the adjuster ring (1) to the desired position with
the special tool.
Special tool
(A): 09910–60611 (Universal clamp wrench)
(A)
Rear Suspension:
2C-6
I940H1230016-01
B940H22306007
" a "
I940H1230017-01
I940H1230018-01
Advertisement
Chapters
Table of Contents
