Suzuki Intruder VZ1500 Service Manual page 433

• Install the inner race (7), washer (8), bearing (9) and
inner race (10) with the special tool.
Special tool
(F): 09913–84510 (Bearing installer)
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
7
• Install the correct shims (11) to the final drive bevel
gear, and install the bevel gear to the final gear case.
• Apply grease to the O-ring and the lip of the oil seal.
• Install the bearing stopper (12).
CAUTION
!
Use a new oil seal and O-ring to prevent oil
leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(F)
(F)
10
9
8
I822H1310075-03
11
I822H1310076-01
12
I822H1310077-01
Drive Chain / Drive Train / Drive Shaft:
• Tighten the bearing stopper (12) to the specified
torque with the special tool.
Special tool
(G): 09924–62410 (Final drive gear bearing
holder wrench)
Tightening torque
Final drive bevel gear bearing stopper (c): 110
N·m (11.0 kgf-m, 79.5 lbf-ft)
12
(c)
• Install the final drive gear coupling (13) and washer
(14).
• Apply a small quantity of the thread lock to the final
drive gear coupling nut.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
3A-19
(G)
I822H1310078-02
14
13
I822H1310079-01