Table of Contents
Advertisement
1J-4 Charging System:
5) Connect the battery (–) terminal and install the seat.
Refer to "Battery / Battery Holder Removal and
Installation (Page 1J-11)" and "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
5)".
Regulated Voltage Inspection
Inspect the regulated voltage in the following
procedures:
1) Remove the seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-5)".
2) Connect the special tool to the high-tension cord.
Special tool
: 09900–26006 (Engine tachometer (solar
cell type))
3) Start the engine and keep it running at 5 000 r/min
with the dimmer switch turned HI position.
4) Measure the DC voltage between the battery (+) and
(–) terminals using the multi-circuit tester. If the
voltage is not within the specified value, inspect the
generator and regulator/rectifier. Refer to "Generator
Inspection (Page 1J-4)" and "Regulator / Rectifier
Inspection (Page 1J-8)".
NOTE
When making this test, be sure that the
battery is in fully charged condition.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Voltage (
)
Regulated voltage (Charging output)
Standard: 13.5 – 15.5 V at 5 000 r/min
5) Install the seat. Refer to "Exterior Parts Removal and
Installation in Section 9D (Page 9D-5)".
B940H21A06002
Battery
(DCV)
Tester
I649G11A0003-02
Generator Inspection
Generator Coil Resistance
1) Remove the left frame lower cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-5)".
2) Remove the regulator/rectifier (1) from the bracket.
3) Disconnect the generator coupler (2).
2
4) Measure the resistance between the three lead
wires.
If the resistance is out of specified value, replace the
stator with a new one. Also, check that the generator
core is insulated properly.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Resistance (Ω)
Generator coil resistance
0.2 – 0.6 Ω (B – B)
∞ Ω (B – Ground)
5) Connect the generator coupler.
No-load Performance
1) Remove the left frame lower cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-5)".
2) Remove the regulator/rectifier (1) from the bracket.
3) Disconnect the generator coupler (2).
B940H21A06003
1
I940H11A0001-03
B
B
B
I827H11A0003-02
Advertisement
Chapters
Table of Contents
