Table of Contents
Advertisement
1I-11 Starting System:
5) Hold the generator rotor and remove the starter
clutch bolts.
6) Remove the one way clutch (6) from the guide (7).
Installation
Install the starter clutch in the reverse order of removal.
Pay attention to the following points:
• When inserting the one way clutch (1) into the guide
(2), fit the flange "A" in the step of the guide (2).
NOTE
Be sure to seat the flange "A" of the one way
clutch (1) to the guide (2).
2
I940H1190024-01
7
6
I940H1190025-02
1
"A"
I940H1190026-01
• Install the guide (2) to the generator rotor.
NOTE
The arrow mark "B" must face to the
generator rotor side.
"B"
• Apply thread lock to the bolts, and then tighten them
to the specified torque with the special tool.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Starter clutch bolt (a): 25 N·m (2.5 kgf-m, 18.0 lbf-
ft)
I718H1190031-01
2
I940H1190027-02
(a)
I940H1190028-01
Advertisement
Chapters
Table of Contents
