Suzuki Intruder VZ1500 Service Manual page 337

3) Disconnect the starter motor read wire (2).
2
4) Remove the starter motor (3) from the left side of the
motorcycle.
3
Installation
Install the starter motor in the reverse order of removal.
Pay attention to the following points:
• Apply grease to the starter motor O-ring.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
Replace the O-ring with a new one.
I940H1190002-01
3
I940H1190003-01
I940H1190035-01
• Connect the starter motor lead wire.
Tightening torque
Starter motor lead wire mounting nut (a): 6 N·m (
0.6 kgf-m, 4.5 lbf-ft)
• Tighten the starter motor mounting bolt (1) to the
specified torque.
Tightening torque
Starter motor mounting bolt (b): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
1
(b)
Starting System:
I940H1190004-01
(a)
I940H1190005-01
I940H1190006-01
1I-4