Tp Sensor Adjustment; Iat Sensor Removal And Installation - Suzuki Intruder VZ1500 Service Manual

TP Sensor Adjustment

Inspect the TP sensor setting position and adjust it if
necessary in the following procedures:
1) Connect the special tool (Mode select switch) to the
dealer mode coupler. Refer to "Self-Diagnostic
Procedures in Section 1A (Page 1A-11)".
Special tool
: 09930–82720 (Mode select switch)
2) Turn the mode select switch ON.
3) Check the position of the bar in the left of C code
displayed on the LCD panel.
"A": Incorrect position
4) Loosen the TP sensor mounting screw using the
special tool and turn the TP sensor to bring the bar
to the correct position.
Special tool
: 09930–11950 (Torx wrench)
5) Tighten the TP sensor mounting screw to the
specified torque.
Tightening torque
TP sensor mounting screw: 3.5 N·m (0.35 kgf-
m, 2.5 lbf-ft)
6) Turn off the engine and install the right air cleaner
box. Refer to "Air Cleaner Element Removal and
Installation in Section 1D (Page 1D-6)".
B940H21306008
"A"
"B"
"A"
I823H1130022-01
"B": Correct position
I940H1130007-01
Engine Electrical Devices:

IAT Sensor Removal and Installation

Removal
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
2) Disconnect the IAT sensor coupler (1) and remove
the IAT sensor (2) by removing the mounting screw.
2
Installation
Install the IAT sensor in the reverse order of removal.
Pay attention to the following point:
• Tighten the IAT sensor mounting screw (1) to the
specified torque.
Tightening torque
IAT sensor mounting screw (a): 1.3 N·m (0.13 kgf-
m, 1.0 lbf-ft)
1C-3
B940H21306009
1
I940H1130028-01
1
(a)
I940H1130029-01