Table of Contents
Advertisement
Installation
1) Apply bond to the mating surface of the final gear
case and swingarm.
: Sealant 99000–31110 (SUZUKI BOND
No.1215 or equivalent)
CAUTION
!
When installing the stopper plate, fit the
protrusion "A" of the plate to the one of the
bearing stopper grooves.
2) Apply moly paste to the propeller shaft spline.
: Moly paste 99000–25140 (SUZUKI MOLY
PASTE or equivalent)
3) Install the universal joint (1) to the rear propeller
shaft (2) and install the final gear assembly.
NOTE
To install the final gear case easily, move the
dust boot front and the universal joint turn
into the propeller shaft.
"A"
I940H1310003-02
I940H1310018-01
Drive Chain / Drive Train / Drive Shaft:
1
4) Install the washers (3) and tighten the final gear case
nut (4) to the specified torque.
NOTE
The conical side of the washer (3) faces
outside.
Tightening torque
Final gear case nut (a): 40 N·m (4.0 kgf-m, 29.0
lbf-ft)
4
(a)
5) Install the swingarm cover (5) and tighten the
mounting bolts (6) and final gear case pivot bolt (7).
6
3A-13
2
I940H1310004-01
3
I940H1310005-01
5
7
I940H1310006-01
Advertisement
Chapters
Table of Contents
