Suzuki Intruder VZ1500 Service Manual page 434

3A-20 Drive Chain / Drive Train / Drive Shaft:
• Tighten the nut to the specified torque with the special
tool.
CAUTION
!
Use a new nut.
Tightening torque
Final drive gear coupling nut (d): 100 N·m (10.0
kgf-m, 72.5 lbf-ft)
Special tool
(H): 09924–62430 (Long socket (22 mm))
(I): 09924–64510 (Final driving gear coupling
holder)
• Lock the final drive bevel gear coupling nut with a
center punch.
(H)
(I)
• Apply 5 – 7 cm 3 Lithium Base Molybdenum grease
(NLGI#2) to the propeller shaft splines and final drive
bevel gear coupling.
• Install the spring (15) and propeller shaft (16).
: Moly paste 99000–25140 (SUZUKI MOLY
PASTE or equivalent)
(d)
I822H1310080-03
15
16
I940H1310059-01
• Install the snap ring (17).
• After installing the propeller shaft with a new snap
ring, make sure that the propeller shaft turns smoothly
without any hitch or bearing noise.
Special tool
: 09900–06108 (Snap ring pliers)
17
• Apply grease to the lip of the dust seal.
CAUTION
!
Use a new dust seal to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the dust seal with the special tools.
Special tool
(J): 09940–51410 (Bearing installer)
(K): 09925–18011 (Steering bearing installer)
(J)
(K)
I822H1310082-03
I822H1310083-02
I822H1310084-02