Suzuki Intruder VZ1500 Service Manual page 383

10) Hold the swingarm pivot shaft (6) with the special
tool and remove the swingarm pivot shaft nut (7).
Special tool
(A): 09900–18720 (Hexagon socket (14
mm))
6
(A)
11) Remove the swingarm assembly.
12) Remove the rear shock absorber (8).
13) Remove the cushion lever (9) and cushion rod (10).
10
14) Remove the spacer (11), cushion rod seal (12), and
7
I940H1230007-01
Installation
Install the swingarm in the reverse order of removal. Pay
attention in the following points:
8
• Install the cushion rod bearing (1) with the special tool
I940H1230008-01
10
9
I940H1230009-01
cushion rod bearing (13) with the special tools.
Special tool
(B): 09923–73210 (Bearing remover)
: 09930–30104 (Rotor remover sliding shaft)
12
11
CAUTION
!
The removed bearings and cushion rod seals
must be replaced with new ones.
as shown in the rear suspension assembly
construction. Refer to "Rear Suspension Assembly
Construction (Page 2C-2)".
Special tool
(A): 09941–34513 (Steering race installer)
(B): 09924–84510 (Bearing installer set)
1
Rear Suspension: 2C-4
13
(B)
I940H1230010-03
(A)
(B)
I940H1230038-01