Suzuki Intruder VZ1500 Service Manual page 389

Swingarm Bearing
1) Insert the spacers into bearings.
2) Check the play by moving the spacers up and down.
If excessive play is noted, replace the bearing with a
new one. Refer to "Swingarm Bearing Removal and
Installation (Page 2C-11)".
Swingarm
Inspect the swingarm for damage. If any defect is found,
replace the swingarm with a new one.
Cushion Rod Bearing
1) Insert the spacer into bearings.
2) Check the plat by moving the spacers up and down.
If excessive play is noted, replace the bearing with a
new one. Refer to "Swingarm Assembly Removal
and Installation (Page 2C-3)".
Cushion Rod
Inspect the cushion rods for damage and bend. If any
defects are found, replace the cushion rods with new
ones.
Swingarm Pivot Shaft
I940H1230031-01
Measure the swingarm pivot shaft runout using the dial
gauge. If the runout exceeds the service limit, replace
the pivot shaft.
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100 mm))
Swingarm pivot shaft runout
Service limit: 0.3 mm (0.01 in)
I940H1230032-01
I940H1230033-01
Rear Suspension:
I940H1230034-01
(A)
(B)
(C)
I649G1230034-03
2C-10