PoE configuration using the CLI
Enabling and disabling PoE card notification control
Enable the notification control on the PoE card of the Ethernet Routing Switch 8300 to receive
notification messages.
Procedure steps
Enable the notification control on the PoE card by using the following command:
config poe card <slotlist> notification-control
Variable definitions
Use the data in the following table to help you use the config poe card <slots>
notification-control command.
Variable
notification-control
<enable|disable>
PoE port settings configuration
Use the procedures in this section to configure the PoE port on the Avaya Ethernet Routing
Switch 8300.
PoE port settings configuration navigation
•
Enabling and disabling PoE port power administration
•
Setting PoE port power priority
•
Setting PoE port power limit
•
Setting PoE port power detection control
•
Setting PoE port type
44
Configuration — Power over Ethernet
Sets the notification control on the PoE card.
The enable setting enables all notification messages to the
notification receiver or a log file.
The disable setting disables all notification messages to the
notification receiver or to a log file.
The default is enable.
on page 45
on page 46
on page 46
on page 47
Value
on page 45
May 2011