Configuring Port-Based Aes Using Acli; Activating Or Deactivating Aes Manually Using Acli - Avaya 4524GT Configuration Manual

System configuration using ACLI

Configuring port-based AES using ACLI

Use the following procedure to enable or disable energy saving for the accessed port, an
alternate individual port, or a range of ports.
Prerequisites
• Disable AES globally.
• Log on to the Interface Configuration mode in ACLI.
Procedure steps
Configure port-based AES by using the following command:
[default] [no] energy-saver <enable> [port <portlist> enable]
Variable definitions
The following table defines optional parameters that you enter after the [default] [no]
energy-saver <enable> [port <portlist> enable] command.
<enable>
[no]
port <portlist> enable

Activating or deactivating AES manually using ACLI

Use the following procedure to have AES enabled, but not activated. Activate AES to ensure
that AES is enabled and activated.
202 Configuration — System
Variable
Variable
Value
Important:
You must disable AES globally before you
can modify POE power saving.
Value
Enables AES for the accessed port.
Disables AES for the accessed port, an
alternate port, or list of ports.
Enables AES for a port or list of ports.
April 2011