Changing Subnet Netmask Value - Avaya 3500 Quick Start Configuration

show ip address
Example
The following figure displays a sample output for the show ip address command.
Switch>show ip address
Stack IP Address:
Switch IP Address:
Switch Subnet Mask:
Note:
The Router and DNS IP addresses are global, or common. Addresses and pools that do not
have Router and DNS addresses configured within them use these global addresses.

Changing subnet netmask value

The subnet mask is configured using procedure
procedure to change the subnet mask to the default value or clear the subnet mask.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
[default] [no] ip netmask
Variable definitions
The following table describes the parameters for the ip netmask command.
Variable
default
no
September 2016
Configured
------------- -------------
172.16.120.10
172.16.120.12 172.16.120.12
255.255.255.0 255.255.255.0
Quick Start Configuration
Comments on this document? infodev@avaya.com
In Use Last BootP/DHCP
---------------
0.0.0.0
0.0.0.0
0.0.0.0
Configuring the IP address
Value
Sets the subnet mask to the default value
(255.255.255.0).
Sets the subnet mask for a switch to all zeros
(0.0.0.0).
Changing subnet netmask value
on page 40. Use this
43