Changing Configuration - Avaya 8300 Configuration

Changing configuration

This section shows a configuration change to the example shown in the figure
configuration example
In this example, the 8348TX-PWR or 8348GTX-PWR in slot 8 is needed in another chassis.
Therefore, you must move the PDs in slot 8 to slot 7.
Procedure steps
1. View the PoE system information for the total power available by using the following
2. The amount of PoE power needed to move the existing PDs to slot 7 is 80 watts.
Configuration — Power over Ethernet
b. Disable transmission of all notification messages on slot 7 by using the
following command:
ERS-8310:5#
config poe card 7 notification-control disable
c. Enable transmission of all notification messages on slot 7 by using the
following command:
ERS-8310:5#
config poe card 7 notification-control enable
on page 60.
command:
ERS-8310:5#
show poe sys info
This command shows that 200 watts of PoE power is available because you
removed the slot 8 module.
You can allocate 100 watts of the Total Available PoE Power to slot 7 to
accommodate these PDs. Change the Main Power Limit of 200 W. Changing it to
300 W to allocate the additional 100 W needed.
Configure the power limit on the PoE card by using the following commands:
ERS-8310:5#
config/poe/card/7# power-limit 300
Changing configuration
Figure 2: PoE
May 2011 63