Service-Acl Output - Cisco Sx350 Cli Manual

ACL Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
switchxxxxxx(config-mac-al)# permit 00:00:00:00:00:01 00:00:00:00:00:ff any
switchxxxxxx(config-mac-al)# exit
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# service-acl input server-acl default-action deny-any

2.11 service-acl output

Use the service-acl output command in Interface Configuration mode to control
access to an interface on the egress (transmit path).
Use the no form of this command to remove the access control.
Syntax
service-acl output acl-name1 [
no service-acl output
Parameters
acl-name-Specifies an ACL to apply to the interface. See the usage guidelines.
(Range: acl-name is from 0-32 characters. Use "" for empty string)
Default
No ACL is assigned.
Command Mode
Interface Configuration mode(Ethernet, Port-Channel).
User Guidelines
The rule actions: log-input is not supported. Trying to use it will result in an error.
The deny rule action disable-port is not supported. Trying to use it will result in an
error.
IPv4 and IPv6 ACLs can be bound together on an interface.
A MAC ACL cannot be bound on an interface together with an IPv4 ACL or IPv6
ACL.
Two ACLs of the same type cannot be added to a port.
1
acl-name2
]
2
68