3.5
Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
◆ Removing/Reattaching the Terminal Cover
Removing the Terminal Cover
■
Models CIMR-LU20008 to 20075, 40005 to 40039, and 50003 to 50027
1.
Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by drive model.
Figure 3.3
2.
Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal
cover.
Figure 3.4
Models CIMR- LU20085 to 20415, 40045 to 40605, and 50003 to 50027
1.
Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminal
cover may fall off causing an injury.
Note: The shape of the terminal covers and the numbers of screws differ depending on the drive models. Refer to
page 31
for details.
Figure 3.5
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Figure 3.4 Removing the Terminal Cover
Figure 3.5 Removing the Terminal Cover
Figure 3.6 Removing the Terminal Cover
YEA_common
YEA_common
YEA_common
3.5 Terminal Cover
Component Names on
63
3