O3: Copy Function - YASKAWA L1000A Technical Manual

5.10 o: Operator Related Settings
■ o2-06: Operation Selection when Digital Operator is Disconnected
Determines whether the drive will stop when the digital operator is removed in LOCAL mode or when b1-02 is set to 0.
When the operator is reconnected, the display will indicate that it was disconnected.
No.
o2-06
Setting 0: Continue operation
The operation is continued.
Setting 1: Trigger a fault
The operation is stopped and an "oPr" fault is triggered. The motor coasts to stop.

◆ o3: Copy Function

These parameters control the Copy function of the digital operator. The Copy function stores parameter settings into the
memory of the digital operator to facilitate the transfer of those settings to other drives that are the same model, capacity,
and same control mode setting. Refer to
displays.
o3-01 Copy Function Selection
■
Instructs the drive to Read, Write, or Verify parameter settings.
No.
o3-01
Setting 0: Copy Select (no function)
Setting 1: INV → OP READ
Copies all parameters from the drive to the digital operator.
Note: The copy protection for the digital operator is enabled by default. Set o3-02 to 1 to unlock copy protection.
Setting 2: OP → INV WRITE
Compares the parameters in the drive with the parameter settings saved on the digital operator for matches.
Setting 3: OP ↔ INV VERIFY
Parameters in the drive are compared with the parameter settings saved on the digital operator to see if they match.
o3-02 Copy Allowed Selection
■
Allows and restricts the use of the Copy function.
No.
o3-02
Setting 0: Disabled
Setting 1: Enabled
254
Parameter Name
Digital Operator Disconnection Operation
Copy Function Related Displays on page 311
Parameter Name
Copy Function Selection
Parameter Name
Copy Allowed Selection
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Setting Range
0 or 1
for a description of errors and
Setting Range
0 to 3
Setting Range
0 or 1
Default
0
Default
0
Default
0