The Drive And Programming Modes - YASKAWA L1000A Technical Manual

4.3 The Drive and Programming Modes

4.3 The Drive and Programming Modes
The drive has a Drive Mode to operate the motor and a Programming Mode to edit parameter settings.
Drive Mode: In Drive Mode the user can operate the motor and observe U Monitor parameters. Parameter settings cannot
be edited or changed when in Drive Mode.
Programming Mode: In Programming Mode the user can edit and verify parameter settings and perform Auto-Tuning.
The drive will not accept an Up/down command when the digital operator is in the Programming Mode unless parameter
b1-08 is set to 1 to allow an Up/down command.
Note: 1. If b1-08 is set to 0, the drive will only accept an Up/Down command in Drive Mode. After editing parameters, the user must exit the
Programming Mode and enter Drive Mode before operating the motor.
2. Set b1-08 to 1 to allow the drive to run the motor while in Programming Mode.
◆ Navigating the Drive and Programming Modes
The drive is set to operate in Drive Mode when it is first powered up. Switch between display screens by using the
and keys.
Mode Contents
Speed Reference
Power Up
(default)
Drive Mode
Monitor Display
Verify Menu
Programming
Setup Group
Mode
Parameter Setting
Mode
98
Operator Display
- MODE - DRV Rdy
Speed Ref (OPR)
This display screen allows the user to monitor and change the speed reference while the drive is running.
YEA_common
U1-01= 0.00%
The Drive and Programming Modes on page
Note: The user can select the data displayed when the drive is first powered up with parameter o1-02.
U1-02= 0.00%
RSEQ
U1-03= 0.00A LREF
FWD FWD/REV
- MODE - DRV Rdy
Monitor Menu
Lists the monitor parameters (U- parameters) available in the drive.
U1-01= 0.00%
YEA_common
Press the Enter Key and then use the Up, Down, ESC, and Reset keys to navigate through the drive monitors.
U1-02= 0.00%
RSEQ
U1-03= 0.00A LREF
FWD FWD/REV
- MODE - PRG
Modified Consts
Lists all parameters that have been edited or changed from default settings.
YEA_common
Modified
Changes: Verify Menu on page
X Parameters
FWD
HELP DATA
- MODE - PRG
Quick Setting
A select list of parameters necessary to get the drive operating quickly.
page 102.
YEA_common
HELP
FWD DATA
- MODE - PRG
Programming
Allows the user to access and edit all parameter settings.
YEA_common
HELP FWD
DATA
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Description
98.
101.
Refer to Parameter Table on page
Refer to
Refer to Verifying Parameter
Refer to Using the Setup Group on
394.