Fault Reset Methods - YASKAWA L1000A Technical Manual

◆ Fault Reset Methods

When a fault occurs, the cause of the fault must be removed and the drive must be restarted. The table below lists the
different ways to restart the drive.
After the Fault Occurs
Fix the cause of the fault, restart the drive, and
reset the fault
Resetting via Fault Reset Digital Input S4
If the above methods do not reset the fault, turn off the drive main power supply. Reapply power after the digital
operator display is out.
Note: If the Up/Down command is present, the drive will disregard any attempts to reset the fault. Remove the Up/Down command
before attempting to clear a fault situation.
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Procedure
Press on the digital operator when error code is
displayed.
Close then open the fault signal digital input via terminal S4.
S4 is set for "Fault Reset" as default (H1-04 = 14).
6.8 Diagnosing and Resetting Faults
DIGITAL OPERATOR JVOP-180 ALARM
YEA_
- MODE - DRV
oC
Overcurrent
RESET
FWD
F1 F2
RESET
LO
ESC
RE
RESET ENTER
RUN STOP
Drive
Fault Reset Switch
S4 Fault Reset Digital Input
SC Digital Input Common
ON
2
OFF
1
6
315