Option Card Installation - YASKAWA L1000A Technical Manual

8.4 Option Card Installation

8.4 Option Card Installation
This section provides instructions on installing the option cards listed in
◆ Prior to Installing the Option
Prior to installing the option, wire the drive, make the necessary connections to the drive terminals, and verify that the
drive functions normally. Refer to the
Table 8.2 below lists the number of option cards that can be connected to the drive and the drive connectors for
connecting those option cards.
Option Card
PG-B3, PG-X3
PG-F3 , PG-E3
<2>
DO-A3, AO-A3
SI-S3, DI-A3
<3>
<1> If two PG option cards are connected, use both CN5-B and CN5-C. If only one PG option card is connected to the drive, use the CN5-C
connector.
<2> These option cards are not available for the application with Motor 2 Selection.
<3> When DI-A3 is to be used as monitors, the card can be connected to any of CN5-A, CN5-B or CN5-C. The input status of DI-A3 can
then be viewed using U1-17.
Figure 8.2 shows an exploded view of the drive with the option and related components for reference.
Figure 8.2
A – Insertion point for CN5
B – Option card
C – Included screws
D – Front cover
E – Digital operator
F – Terminal cover
356
Table 8.2 for information on wiring and connecting the drive.
Table 8.2 Option Card Installation
Connector
CN5-C
CN5-C
CN5-A, B, C
CN5-A
L
K
J
I
H
G
Figure 8.2 Installing an Option Card
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Table 8.2.
Number of Cards Possible
A
B
C
D
E
F
G – Removable tabs for wire routing
H – Ground wire
I – Drive grounding terminal (FE)
J – Connector CN5-A
K – Connector CN5-B
L – Connector CN5-C
2
<1>
1
1
1
YEA_common