D.3 UL and CSA Standards
◆ UL Standards Compliance
The UL/cUL mark applies to products in the United States and Canada. It indicates that UL has performed product testing
and evaluation, and determined that their stringent standards for product safety have been met. For a product to receive
UL certification, all components inside that product must also receive UL certification.
Figure D.7
This drive is tested in accordance with UL standard UL508C and complies with UL requirements. To ensure continued
compliance when using this drive in combination with other equipment, meet the following conditions:
Installation Area
■
Do not install the drive to an area greater than pollution degree 2 (UL standard).
■
Ambient Temperature
IP00 enclosure with top protective cover: -10 to +40°C (14 to 104°F)
IP00 enclosure: -10 to +50°C (14 to 122°F)
Main Circuit Terminal Wiring
■
Yaskawa recommends using closed-loop crimp terminals on all drive models. UL/cUL approval requires the use of UL
Listed closed-loop crimp terminals when wiring the drive main circuit terminals on models CIMR-LU20085 through
20415, 40045 through 40605, and 50032 to 50200. Use only the tools recommended by the terminal
manufacturer for crimping.
The wire gauges listed in
Table D.4
gauge selections.
Table D.4 Wire Gauge and Torque Specifications (Three-Phase 200 V Class)
Model
CIMR-LU
R/L1, S/L2, T/L3
U/T1, V/T2, W/T3
–, +1, +2
20008
B1, B2
R/L1, S/L2, T/L3
U/T1, V/T2, W/T3
–, +1, +2
20011
B1, B2
R/L1, S/L2, T/L3
U/T1, V/T2, W/T3
–, +1, +2
20014
B1, B2
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Figure D.7 UL/cUL Mark
and
Table D.5
are Yaskawa recommendations. Refer to local codes for proper wire
Recommended Gauge
Terminal
AWG, kcmil
14
14
10
12
14
10
10
10
10
Applicable Gauge
AWG, kcmil
14 to 10
14 to 10
–
14 to 10
–
14 to 10
14 to 10
<1>
14 to 10
14 to 10
–
14 to 10
–
14 to 10
14 to 10
<1>
12 to 10
14 to 10
–
14 to 10
–
14 to 10
14 to 10
<1>
D.3 UL and CSA Standards
Screw
Tightening Torque
Size
Nm (lb.in.)
1.2 to 1.5
M4
(10.6 to 13.3)
1.2 to 1.5
M4
(10.6 to 13.3)
1.2 to 1.5
M4
(10.6 to 13.3)
D
481