Digital Operator And - YASKAWA L1000A Technical Manual

3.6 Digital Operator and Front Cover
Detach the digital operator from the drive for remote operation or when opening the front cover to install an option card.
Note: Be sure to remove the digital operator prior to opening or reattaching the front cover. Leaving the digital operator plugged into the
drive when removing the front cover can result in erroneous operation caused by a poor connection. Firmly fasten the front cover
back into place before reattaching the digital operator.
◆ Removing/Reattaching the Digital Operator
Removing the Digital Operator
■
While pressing on the tab located on the right side of the digital operator, pull the digital operator forward to remove it
from the drive.
Figure 3.9
■ Reattaching the Digital Operator
Insert the digital operator into the opening in the top cover while aligning it with the notches on the left side of the
opening.
Next, press gently on the right side of the operator until it clicks into place.
Figure 3.10
◆ Removing/Reattaching the Front Cover
Removing the Front Cover
■
Models CIMR- LU20008 to 20075, 40005 to 40039, and 50003 to 50027
After removing the terminal cover and the digital operator, loosen the screw that affixes the front cover (model
CIMR-LU20047, 40024, 40031, 50017, and 50022 does not use a screw to affix the front cover). Pinch
inwards on the tabs found on each side of the front cover, then pull forward to remove it from the drive.
Figure 3.11
Figure 3.12 Remove the Front Cover (Models CIMR-LU20008 to 20075, 40005 to 40039, and 50003 to 50027)
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
Figure 3.10 Removing the Digital Operator
Figure 3.11 Reattaching the Digital Operator
3.6 Digital Operator and Front Cover
YEA_common
YEA_common
YEA_common
3
65