Mounting And Connecting The Camera - Avaya H175 User Manual

Setting up H175 Video Collaboration Station
Procedure
1. Perform the following steps only if you are replacing the wireless handset with the wired
handset, else skip the steps.
a. From the back of the device, remove the screw that is below the charging pins bushing.
b. Remove the charging bushing plastic.
c. Attach the blind bushing plastic cover from the top and secure it with a screw.
2. Plug non-spiral end of the handset cord into the handset connector on the Collaboration
Station.
3. Plug the other end into the connector in the handset.
4. Disable the wireless handset.
Related links
Hardware setup and login

Mounting and connecting the camera

Procedure
• For integrated mount:
1. Position the camera on the Collaboration Station.
2. Fold the camera leg and insert the camera latch in the twist lock at the back of the
Collaboration Station.
3. Plug one end of the camera cable into the camera connector of the Collaboration Station.
Plug the other end into the connector in the camera.
• For external mount:
1. Position the camera on the external monitor and open the camera leg to balance the
camera properly.
2. Plug one end of the camera cable into the camera connector of the Collaboration Station.
Plug the other end into the connector in the camera.
3. Plug one end of the video cable into the video display out connector of the Collaboration
Station. Plug the other end into the video display in connector of the external monitor.
Related links
Hardware setup and login
Camera on page 60
April 2016
on page 45
on page 45
Using Avaya H175 Video Collaboration Station
Comments on this document? infodev@avaya.com
50