Connecting The Ptz Camera - Avaya XT Series Deployment Manual

Setting Up the XT Series Hardware

Connecting the PTZ Camera

About this task
This procedure describes how to connect the main PTZ camera to the Avaya Room System XT
Series. The XT7000 and XT5000 use the XT Premium Camera or the Avaya XT Series Deluxe
Camera. The XT4300 uses the XT Flex Camera.
For details about the camera's capabilities, see
information about the room setup, see
Procedure
1. Place the camera in a position to ensure eye contact between local and remote
participants.
If the XT Codec Unit is housed in a cabinet, the XT Remote Control Unit sends the signal
to the infra-red receiver of the main camera to relay messages to the XT Codec Unit. In
this case, configure the camera settings so the camera's power is always on (see
Configuring Cameras
Try positioning the camera between the two monitors either directly above or below them,
at a distance which captures all the seats.
Caution:
Do not place the camera on top of the XT Codec Unit. It can cause the system to
overheat.
August 2020
Figure 24: Flex Camera
Figure 25: Deluxe Camera
Technical Specifications
Planning the Optimal Room Setup
on page 126).
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
on page 20. For more
on page 52.
60