Engine; Radiator & Oil Cooler Replacement; Radiator & Oil Cooler Assembly Removal - Toro TX525 Service Manual

Radiator & Oil Cooler Replacement
Radiator & Oil Cooler Assembly Removal
Note: Cleanliness is a key factor for any service
work involving the hydraulic system. Thor­
oughly clean all exposed surfaces prior to
any type of maintenance. Cleaning all parts by
using a solvent wash and air drying is usually
adequate. As with any precision equipment,
all parts must be kept free of foreign material
and chemicals. Protect all exposed sealing
areas and open cavities from damage and
foreign material.
Upon removal, all seals, o­rings, and gaskets
should be replaced. During installation, lightly
lubricate all seals, o­rings, and gaskets with
clean petroleum jelly prior to assembly.
Protect the inner diameter of seals and
o­rings from damage during assembly by
covering the shaft machined features with
plastic wrap or equivalent.
1. Park the machine on a flat surface and raise the
hood.
2. Raise the loader arm and lock the loader arm into
position using the loader arm lock.
3. Turn the machine off and remove the key. Allow the
machine to cool.
TX525 Service Manual
4. Remove the left and right hand side panels (Fig.
0080).
5. Remove the breather from the breather tube (Fig.
0081).
Rev. 000

ENGINE

Fig 0080 PICT-4945
Fig 0081 PICT-4946a
4-1