Page 1
Form No. 3429-975 Rev B Standard Bucket, High-Volume Bucket, or Grading Bucket TXL 2000 Tool Carrier Model No. 22546—Serial No. 318000001 and Up Model No. 22547—Serial No. 318000001 and Up Model No. 22548—Serial No. 318000001 and Up Model No. 22576—Serial No. 318000001 and Up *3429-975* B Register at www.Toro.com.
Page 2
1. Model and serial number location The bucket is a load-bearing attachment intended to be used on a Toro tool carrier. It is designed primarily for moving rock, dirt, sand, or other materials. Using this product for purposes other than its intended use could prove dangerous to you and bystanders.
Contents Safety Safety ............... 3 DANGER General Safety ........... 3 Slope Safety ............4 There may be buried utility lines in the work Bucket Safety ............. 4 area. Digging into them may cause a shock Maintenance and Storage Safety......4 or an explosion.
Slope Safety • Use caution when operating the machine near the following: • Operate the machine up and down slopes with – Drop-offs the heavy end of the machine uphill. Weight distribution changes with attachments. An empty – Ditches load-bearing attachment makes the rear of the –...
Replace any decal that is damaged or missing. decal139-2836 139-2836 1. Tipping hazard—read the TXL 2000 Operator’s Manual for load limits; the maximum load with the attachment retracted is 887 kg (1,956 lb); the maximum load with the attachment decal125-6110 extended is 412 kg (909 lb).
Capacity (SAE struck 0.8 m (29.0 ft capacity) 1. Tipping hazard—read the TXL 2000 Operator’s Manual for load limits; the maximum load with the attachment retracted is 852 kg (1,880 lb); the maximum load with the attachment Model 22547—Standard Bucket extended is 410 kg (905 lb).
Maximum Material Density at Material Density Capacity Material Density (Approximate) Caliche 1250 kg/m (78 lb/ft The density of the materials moved by the bucket varies and, therefore, so does the amount of material Clay: that the bucket can carry before reaching the Natural bed 1600 kg/m (104 lb/ft...
Filling the Bucket Operation Position the bucket level to the ground. Determine the left and right sides of the machine from Drive forward and insert the bucket into the pile the normal operating position. of material. When the bucket is full, drive the machine in Installing and Removing reverse and gently tilt the bucket rearward to decrease the lifting resistance when you lift the...
Transport Position Storage When transporting a load, keep the attachment as Before long-term storage, wash the attachment close to the ground as possible, no more than 15 cm with mild detergent and water to remove dirt and (6 inches) above the lowest position. Tilt it rearward to grime.
Page 12
While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.