Wide Track Installation - Toro TX525 Service Manual

DRIVE SYSTEM

Wide Track Installation

Important: Before installing the track, use the
Alignment Tool, Toro P/N 110-0069, for proper
alignment between the drive sprocket and the
front tension wheel. Refer to "Track Guide
Alignment" on page 7-3.
1. Install the track, ensuring that the lugs in the track
fit between the spacers in the middle of the drive
sprocket (Fig. 1523).
2. Install the track over the inside tensioner wheel (Fig.
1524).
7-70
Fig 1523 PICT-4495
Fig 1524 PICT-4496
3. Ensure old grease and dirt are cleaned out of the
area between the two washers and the bearings on
the outside tensioner wheel. Fill the area on one side
of the wheel with grease (Fig. 1525).
4. Install the large washer onto the wheel over the
grease (Fig. 1526).
Rev. 000
Fig 1525 PICT-4497
Fig 1526 PICT-4498
TX525 Service Manual