ENGINE
Starter Assembly Rebuild
1. Slide the shaft into the gear (Fig. 0758).
2. Secure the bearing assembly in a vise.
3. Insert the shaft/gear assembly into the bearing
assembly (Fig. 0759).
Note: There is a tab on the gear and bearing for
alignment.
4-180
Fig 0758
PICT-8085a
Fig 0759
PICT-8088
4. While supporting the shaft, slide a washer onto the
shaft (Fig. 0760).
5. While supporting the shaft, install a snap ring (Fig.
0761).
Rev. 000
Fig 0760
PICT-8090a
Fig 0761
PICT-8092a
TX525 Service Manual