Tensioner Arm Replacement - Wide Track; Tensioner Arm Removal - Wide Track - Toro TX525 Service Manual

DRIVE SYSTEM
8. Install the road wheel bearing cap (Fig. 1567).
9. Install the snap ring securing the wheel bearing cap
to the road wheel so that the flat side of the snap
ring is facing away from the road wheel (Fig. 1568).
7-82
Fig 1567 PICT-4525
Fig 1568 PICT-4524
Tensioner Arm Replacement - Wide
Track

Tensioner Arm Removal - Wide Track

1. Lift the machine, refer to "Lifting the Machine for
Service" on page 7-1.
2. Remove the Track. Refer to "Wide Track Removal"
on page 7-68.
3. Raise the loader arms approximately 12" (7cm).
4. Slide the tensioner arm assembly out of the
mainframe (Fig. 1569).
Rev. 000
Fig 1569 PICT-4568
TX525 Service Manual